UAV Disassembly
1, Open UAV top cover.
2, Turn UAV power off and eject the battery.
3, Eject SD card from cameras to to process shooting results.
4, Place UAV on folding rack.
5, Unclasp rubber locks on the wingtips and pull them off the rods. Remove the
rods and ns.
6, Unclasp wings’ rubber locks and pull them 5-10 cm away from UAV body to get
access to the connectors. Disconnect them from autopilot board and take wings
off. Take the rods out and place them in transport case.
7, Close the UAV cover.
8, Fold the parachute and place it parashute compartment.
9, Close the parachute compartment cover and secure it by servo horn.
10, Place UAV parts in transport case.
90
To Next Page
Loading...
