Autopilot Indication
LED Default Error USB Mode
POW blinks slowly blinks fast turned off
ERR turned off lights turned off
STM blinks slowly blinks fast turned off
USB turned off turned off lights
LPC blinks slowly blinks fast lights
11. Open ight project in Geoscan Planner software and connect UAV.
(see Connection Settings section for details)
12. Launch Start Preparing Wizard and complete all steps.
On launch preparing remove lens caps from cameras, install UAV on launcher
and pull rubber cords (springs for «Arctic» launcher).
13. Make sure that you completed all steps successfully and press Done button.
14. Press Start button to switch the UAV to “Catapult” mode. Remove safety pin
and pull launching cord to launch UAV.
The UAV will take off.
15. After launching the UAV, loose rubber cords tension. To do this, hold reel handle
by one hand and use the other to remove reel stopper and smoothly unwind
the tension cable. After that, the cords can be removed from the launcher by
disconnecting the carbine from the cable and the loop from the carriage.
89
To Next Page
Loading...
