7. Place the launcher on at surface, so that the launch would happen against the
wind direction.
UAV should be launched ONLY against the wind direction. Otherwise, it can cause crash
or obstacle collision. When the wind is not blowing at all, add extra coil of rubber bands
from the repair kit on each side of the launcher.
Make sure the launcher stands securely with no pitch to any side. If necessary, push
one of the supports in the ground to level it.
8. Put and hammer stop peg into the hole at the launcher’s rear part. It avoids launcher
displacements.
The stop peg must be hammered to avoid the launcher jumping at the start of the UAV.
Make sure the rear part of the launcher does not get deformed when you hammer on the
peg.
9. Place the carriage onto the guide of the launcher, so that it could slide along
launcher rails.
Carriage placing
31
To Next Page
Loading...
