Administrator Mode
39
5
in the Post-Rec field to continue recording for the number of seconds specified after the
motion detection or I/O trigger event. Use the Pre-Rec field to specify the number of
seconds to start recording before motion is detected or before I/O device is triggered.
2. If Schedule is selected, refer to 5.2.2.C Schedule to see how to set up a recording
schedule.
3. If I/O Trigger is selected, you need to set up the related settings in the I/O Device
Setting above.
4. To apply the settings to all cameras in the Working Camera List, select Apply this
setting to all cameras.
5. Click Save.
[Storage Path] Shows the designated storage path for videos recorded from the camera. To
see how to assign storage path, refer to Setting Storage Path section in Chapter 3 Getting
Started for details.
To Next Page
Loading...
Need help?
General
