Gewa G5 - Description

G5 – Owner‘s Manual | 127
3A1Bh
Threshold: 127=0dB, 64=-6dB, 32=-12dB, 16=-18dB, 8=-24dB, 4=-30dB, 2=-
36dB 0=-Inf
7Fh
3A1Ch
Ratio: 127=1/128, 126=2/128 (1/64), 125=3/128, … 64=64/128 (1/2), … 0=1/1
0
3A1Dh
Boost: 0=1x ... 127=8x
0
3A1Eh
Knee : 0=hard, else soft
0
3A1Fh
Request Input / Gain Reduction / Output levels (see below for Response
message)
-
Note 1: 14bit precision when using NRPN MSB+LSB value, 1 Hz step
20.3.6 COMPRESSOR INPUT / GAIN REDUCTION / OUTPUT LEVELS
RESPONSE PACKET DESCRIPTION
Description
0x4352
Packet Type = "CR" (Compressor Response)
CMP ID
Compressor channel ID (see below)
INP L
Input peak level left
INP R
Input peak level right
GR L
Compressor reduction value left
GR R
Compressor reduction value right
OUT L
Output peak level left
OUT R
Output peak level right
CMP ID is the ID of Compressor channel (0 = Master, 1 = Monitor, 2 = Headphone, "rr" for drum channels)
INP, OUT are values of peak level in dB range from 0 till 70 as follows:
70 = 0dB, 69 = -1dB, 68 = -2dB (1dB steps) ... 64= -6dB ... 0 = -infinite
GR is a value of reduction level in dB range from 0 till 70 as follows:
70 = -70dB, 69 = -69dB, 68 = -68dB (-1dB steps) … 20= - 20dB … 0 = no compression