GRAPHTEC FC2250 Series - Page 110

5-34
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
Procedure
Turn on the plotter while holding down the [ ] key to display the special functions menu on the LCD.
In GP-GL command mode In HP-GL
TM
command mode
LANGUAGE SELECTION
[ English ]
LENGTH UNIT
• mm inch
; , : COMMAND
• ENABLED DISABLED
W COMMAND
TOOL UP TOOL DOWN •
LENGTH UNIT
• mm inch
MODEL EMULATED
• 7550 7595
CONDITION PRIORITY
MANUAL PROGRAM •
TOOL SELECT
• ENABLED DISABLED
INIT. BLADE CONTROL
• 2mm BELOW OUTSIDE
TOOL UP MOVE
ENABLED DISABLED •
PAUSE KEY
HOLDING MENU •
BEEPER
• ENABLED DISABLED
TOOL SELECT WAIT
• ENABLED DISABLED
CIRCLE RESOLUTION
AUTO DEFAULT •
TOOL SELECT WAIT
• ENABLED DISABLED
BEEPER
• ENABLED DISABLED
PAUSE KEY
HOLDING MENU •
TOOL UP MOVE
ENABLED DISABLED •
INIT. BLADE CONTROL
• 2mm BELOW OUTSIDE
TOOL SELECT
• ENABLED DISABLED
CONDITION PRIORITY
MANUAL PROGRAM •
LANGUAGE SELECTION
[ English ]
Press the
[NEXT] key
to cycle through the menus.
The currently selected setting is indicated by a black dot
[
•
].
Press the
[F2]
or
[F4] key
to change the setting as required, and then press the
[ENTER] key
. To cancel your selection
and proceed to the next menu, press the
[NEXT] key
.
Whenyouhavenishedsettingallofthespecialfunctions,turnofftheplotter.
•
Your settings are registered in the plotter's internal memory and retained even while the plotter is turned off.
•
The special functions can also be set by selecting "Function"> "Special Functions" in the PAUSE menu.