5-11
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.10 Assigning Perforation Cutting
This function allows you to assign the perforation cutting operation to COND Nos. 1 to 8.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the
[NEXT] key repeatedly until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
I/F FUNCTION
TOOL COND AREA OPT
(3) Press the [F3] key (TOOL COND) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
THICK CUT LINE
TOOL No. ADJ.T POS
(4) Press the [F3] key (CUT LINE) to display the perforation cutting operation assignment setting screen.
FORCE OFFSET
SPEED QUALITY
COND. No. 12345678
CUT LINE
Blinking cursor
The upper row of the display represents the cutting condition COND Nos. A check mark [ ] is displayed for any of
the COND. Nos. to which the perforation cutting operation has been assigned.
Use the [ ] or [ ] key to move the blinking cursor to the COND. No. that you want to assign the perforation
cutting operation to, and the
[ ] or [ ] key to display or hide the check mark [ ].
Press the [ENTER] keytoconrmyourselections.
(5) Press the
[PAUSE] key to cancel PAUSE mode.
•
These settings are retained in the plotter's internal memory even while the plotter is turned off.
•
Please see Section 3.8, "Setting the Cutting Conditions" for details on perforation settings.
To Next Page
Loading...
