Table of Contents ♦ T - 3
Select the Media Type C3 - 18
ROLL-1 C3 - 18
ROLL-2 C3 - 18
SHEET C3 - 19
CONTINUE C3 - 19
Initializing Routine C3 - 20
ROLL-1 C3 - 20
ROLL-2 C3 - 20
SHEET C3 - 20
CONTINUE C3 - 20
Setting Conditions C3 - 21
Select the Tool from the Menu C3 - 21
TANGENTIAL mode C3 - 22
Cutter Conditions C3 - 23
To Change the Cutter Force C3 - 23
To Change the Cutter Speed C3 - 23
To Change the Cutter Quality C3 - 24
To Change the Cutter Offset C3 - 24
Running Cutting Test C3 - 25
Test 1 C3 - 26
Test 2 C3 - 26
Cutting Pro C3 - 27
Plotter Pen Conditions C3 - 28
Pen reference Values C3 - 28
To Change the Pen Force C3 - 28
To Change the Pen Speed C3 - 29
To Change the Pen Quality C3 - 29
Pounce Conditions C3 - 30
To Change the Pounce Force C3 - 30
To Change the Pounce Speed C3 - 30
To Change the Pounce Quality C3 - 31
To Change the Pounce Offset C3 - 31
Light Pointer Conditions C3 - 32
How to Pint the Target C3 - 32
Checking the Cutter Path C3 - 30
Changing Feed Speed C3 - 33
Withdrawal of the Pen Carriage C3 - 34
Returning the Pen Carriage to Origin C3 - 34
Chapter 4 Advanced Functions and Settings C4 - 1
ORIGIN - Setting the Cutting Origin C4 - 2
Origin Point with ROTATE function C4 - 2
COPY - Copying the Data in Plotter Buffer Memory C4 - 3
Copying Sequence C4 - 5
PEN UP/DOWN - Raising/Lowering the Pen C4 - 6
BUFFER CLEAR - Clearing the Buffer C4 - 7
FEED - Advancing the Media C4 - 8
ORIGIN - Setting the Origin in HP-GL
TM
Mode C4 - 9
AREA - Setting the Cutter Area C4 - 10
EXPAND - Expanding the Cut Area C4 - 13
To Next Page
Loading...
