Table of Contents ♦ T - 4
PAGE LENGTH - Setting the Length of the Page with Roll Media C4 - 16
ROTATE - Rotating the Coordinate Axes C4 - 17
DATA SORTING - Sorting the cut data C4 - 18
MIRROR - Reversing the Image C4 - 20
SCALE - Enlarging and Reducing an Image Size C4 - 21
AXIS ALIGNMENT - Axis Alignment Parameter Setting C4 - 22
Selecting the Axis Alignment Tool C4 - 23
Selecting the Axis Alignment Method C4 - 24
Axis Alignment Adjustment C4 - 26
AUTO PRE FEED - Advancing the Media Automatically C4 - 28
TANGENTIAL EMULATION - Cutting Tiny Letters or Thick & Thin Material C4 - 30
Selecting Tangential Emulation Mode C4 - 30
Enabling the Tangential Emulation C4 - 31
SPEED - Setting the Pen Up Speed C4 - 32
OFFSET ANGLE - Adjusting the Blade Offset Angle C4 - 33
OFFSET FORCE - Setting the Offset Cut Pressure C4 - 34
STEP PASS - Setting the Step Pass C4 - 35
DISTANCE ADJUST - Adjusting the Length of Cut Line Segments C4 - 36
Chapter 5 Background Settings C5 - 1
The MENU TREE of Background Setting C5 - 2
Background Settings for GP-GL C5 - 3
LANGUAGE SELECTION C5 - 3
“:” “;” Command Control (“:” “;” COMMAND) C5 - 3
Pen UP/DOWN for the “W” Command C5 - 4
Condition Priority C5 - 4
Initial Blade Control Position (INIT. BALDE CONTROL) C5 - 5
Length Unit C5 - 5
Pen UP Movement Control (PEN UP MOVE) C5 - 6
Media Size Sensor Control C5 - 6
Pinch Roller Sensor Control C5 - 7
Background Settings for HP-GL C5 - 8
LANGUAGE SELECTION C5 - 8
Model No. Response (MODEL EMULATED) C5 - 8
Condition Priority C5 - 9
Initial Blade Control Position (INIT. BLADE CONTROL) C5 - 9
Length Unit C5 - 10
Pen UP Movement Control (PEN UP MOVE) C5 - 10
Media Size Sensor Control C5 - 11
Pinch roller Sensor Control C5 - 11
Circle Resolution C5 - 12
Chapter 6 Test Modes and Troubleshooting C6 - 1
CONDITION LIST - Listing the Cutter Conditions C6 - 1
Sample printout of the CONDITION function C6 - 2
DATA DUMP - Using the Character Dump Mode C6 - 3
SELF TEST - Running the Self Test C6 - 5
Troubleshooting - The Plotter is Turned on but it Doesn’t Work C6 - 7
Troubleshooting - Improper Initialization C6 - 8
Troubleshooting - Plotter does not Operate Properly C6 - 9
To Next Page
Loading...
