GRAPHTEC FC4100 series - Page 6

Table of Contents ♦ T - 5
Troubleshooting - Poor Cutting Results C6 - 12
Error Messages and Their Cause C6 - 16
Error Messages with their Possible Causes and Probable Solution C6 - 16
Command Error Messages and Their Causes C6 - 18
Error Messages in GP-GL Command Mode C6 - 18
Error Messages in HP-GL Command Mode C6 - 20
Chapter 7 Setting The Interface Function C7 - 1
Setting the Parallel Interface C7 - 1
Setting the Serial Interface C7 - 1
INTERFACE - Setting the Interface Function C7 - 2
How to get to the INTERFACE menu before you have loaded media C7 - 2
How to get to the INTERFACE menu after you have loaded media C7 - 2
STEP SIZE - Setting the Programmable Resolution C7 - 3
RS-232C - Setting the Data Transmitting Conditions C7 - 4
COMMAND - Selecting the Command Mode C7 - 5
Centronics-Compatible Parallel Interface C7 - 6
Specifications C7 - 6
Electrical Characteristics C7 - 6
Input/Output Circuitry C7 - 7
Input/Output Timing Chart C7 - 7
Pin Assignment of the Parallel Connector C7 - 8
RS-232C Serial Interface C7 - 9
Specifications C7 - 9
Electrical Characteristics C7 - 9
Pin Assignment of the Serial Connector C7 - 10
Cable Connection C7 - 10
Chapter 8 Specifications C8 - 1
Main Specifications: FC4100-75 C8 - 1
Main Specifications: FC4100-100 C8 - 2
Main Specifications: FC4100-130 C8 - 3
Options C8 - 4
External Dimensions: FC4100-75 C8 - 5
External Dimensions: FC4100-100 C8 - 6
External Dimensions: FC4100-130 C8 - 7
Chapter 9 Options C9 - 1
FC4100 Pounce Tool Manual C9 - 1
Inserting the Pounce Tool C9 - 2
Select Pounce Tool from the Menu C9 - 3
Pounce Conditions C9 - 3
To Change the Pounce Force C9 - 3
To Change the Pounce Speed C9 - 3
To Change the Pounce Quality C9 - 3
To Change the Pounce Offset C9 - 3
FC4100 Stand Option C9 - 4
Contents C9 - 4
Assemble the Stand C9 - 5
FC4100 Basket Option C9 - 7