GRAPHTEC FC9000 Series - Panel Cutting

4-19
4.3
Panel Cutting
7RSUHYHQWVNHZRIORQJPHGLDXWLOL]H3DQHO&XWWLQJZKHQFXWWLQJ
Supplement

When Panel Cutting is on, the machine will begin by dividing up partition length and continue cutting until one of the following data
EUHDNVDSSHDUV:KHQWKHÀUVWSDUWLWLRQHGDUHDFXWLVÀQLVKHGWKHPDFKLQHZLOOPRYHWRWKHQH[WDUHDDQGUHSHDWWKLVXQWLODOODUHDV
have been cut.

Data Breaks:
 1RGDWDVHQWIRUDIHZVHFRQGDIWHUÀQLVKLQJFXWWLQJ7LPH2XW
(2) A feed-related command is set. (GP-GL: F, FS commands, HP-GL: AF, AH, PG commands)
(3) HP-GL: SP0, NR, GP-GL: J0, SO.
 :KHQFRPPDQGVIURPGDWDEUHDNVDQGDSSHDUWKDWFRPPDQGZRUNZLOOEHJLQDIWHUWKH3DQHO&XWWLQJLVÀQLVKHG

Panel Cutting will continue for each piece of data when a data break is caused by a command, even if multiple pieces of data are
VHQWLQEHIRUHWKHFXWWLQJÀQLVKHVHYHQZKHQQXPHURXVSLHFHVRI3DQHO&XWWLQJGDWDDUHLQWKHSORWWHUEXIIHU

When Panel Cutting and auto media transfer are both turned on, the machine will ignore automatic media transfer length settings
and continue working with priority of partition length plus something minutes ago (with footprints).

When Panel Cutting is on, and registration marks will not be seen ignored, and copy, initial feed, and cutting area cannot be
changed.

3DQHO&XWWLQJFDQQRWEHGRQHZKHQRQHÀOHRIGDWDPDNHVWKHEXIIHUIXOO0DNHVXUHWRDOZD\VVHQGLQGDWDORZHUWKDQWKHEXIIHU
VL]H
Reference
This setting will be saved even if the power is shut off.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETTING screen (1/2) is displayed.