GRAPHTEC FC9000 Series - To Make 3 Cuts with Set Value and ±1 of Set Value

2-44
To make 3 cuts with set value and ±1 of set value
Operation
1
Load the media for test cutting in the plotter.
2
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION setting screen when
you press the [ESC] key (CANCEL).
3
Press the POSITION ( ) key (CUT TEST).
CUT TEST screen is displayed.
Supplement
Pressing the POSITION and [SLOW] keys at the
same time will move the tool carriage slower.
4
Press the POSITION ( ) keys to move the tool carriage
to the location you wish to perform the test cutting.
CAUTION
When the [1] key (FORCE) is pressed, the tool
carriage will start moving, so take care not to get
LQMXUHGE\WKHFXWWHUEODGH
Supplement
Test cut patterns can have their cut order and
force changed as shown below.
+1 0 -1
Cut Order
5
Press the [1] key (FORCE).
3 cutting test patterns are cut, with current FORCE in the center, and 1
each of FORCE increased and decreased for 1.
6
Press the [ENTER] key after completion.
It will return to CUT TEST menu screen.
CAUTION
When the [2] key (CUTTER OFFSET) is
pressed, the tool carriage will start moving, so
WDNHFDUHQRWWRJHWLQMXUHGE\WKHFXWWHUEODGH
7
Press the [2] key (CUTTER OFFSET).
3 cutting test patterns are cut, with current CUTTER OFFSET in the
center, and 1 each of CUTTER OFFSET increased and decreased for 1.
8
Press the [ENTER] key after completion.
It will return to CUT TEST menu screen.