GRAPHTEC FC9000 Series - Move Away the Tool Carriage

3-5
Move away the tool carriage
,WLVSRVVLEOHWRPRYHWKHWRROFDUULDJHWRZDUGXSSHUULJKW,WPDNHVLWHDVLHUWRFRQÀUPWKHFXWWLQJUHVXOWVLI\RX
perform this operation after the cutting is completed.
<When using Roll Media>: Seen from above
Position of the pen carriage
before moving away
To the bottom of the cutting area
(machine origin point)
Standby position of the pen
carriage
100 mm
<When using Sheet Media>: Seen from above
To the top of the
maximum cutting area
Bottom of the operation area
(machine origin point)
Operation
Supplement
When the tool number setting is set to "1", press
the "TOOL 1 MOVE AWAY", and when set to
"3", press the "TOOL 3 MOVE AWAY".
1
Press the [1] key (TOOL1 VIEW) in READY status.
Tool carriage will move away.
To move the tool carriage to the origin point, do following:
Operation
1
Press the [2] key (HOME) in READY status.
Tool carriage will move to the origin point.