GRAPHTEC FC9000 Series - Nomenclature

1-4
1.2
Nomenclature
Front view
This section explains in the FC9000-140.
Tool carriage
Cross cut unit
Tool holder
Control panel
Media set lever
Push rollers
Cutting mat
Pen holder
Cutting groove
Grit rollers
Media stopper
Pen station
Power switch
Grit roller position guide
Media sensors
Power switch ...........................Used to turn the plotter on and off.
Control panel ...........................Used to access various plotter functions.
Push rollers .............................Rollers that push the media against the grit rollers.
Grit rollers ...............................Feeds the media back and forth.
Media sensors ........................The front sensor is used to sense the leading edge of the media. The rear
sensor is used to sense the trailing edge of the media.
Tool carriage ...........................Moves the cutter-pen or plotting pen across the media during cutting or
plotting.
Tool holder ..............................Holds the cutter-pen or plotting pen and moves it up or down.
Grit roller position guide .......$UROOHUSRVLWLRQJXLGHLVDIÀ[HGWRWKHIURQWVLGHRIWKHUDLOZKLFKVKRZVWKH
position of each grit roller. Use these alignment marks as an aid in locating the
Push rollers.
Cutting mat .............................The cutter blade moves on this cutting mat.
Cutting groove ........................Use this groove to cut out (die cut) or cross cut.
Media set lever .......................Used to raise or lower the Push rollers during the loading or unloading of
media.
Media stopper .........................7KLVVWRSVWKHVWRFNVKDIWIURPVSLQQLQJZKHQVHWWLQJLQPHGLD,WLVXWLOL]HG
when pulling roll media straight out.