GRAPHTEC FC9000 Series - ARMS Error Messages

16-9
ARMS Error Messages
Error
Displayed
LCD Display Cause Solution
E04001 7LOWWRDGMXVWZLWK$;,6$/,*10(17LVWRR
large.
Reload the media.
E04004
It is over the setting range of the distance
DGMXVW
Reset to smaller value.
E04005
Could not scan the registration marks. Check the registration scan position.
E04006 Amount of data has exceeded the I/O
EXIIHUVL]HIRUWKHVHJPHQWDUHDUHJLVWUDWLRQ
mark.
Decrease the data.
E04007
Test pattern plotting position is not within
the plotting area for sensor position
DGMXVWPHQW
Move the media toward center and plot the
test pattern.
E04008
Media end was detected while detecting
the registration mark.
Check the media. Check the print position
of the registration mark.
E04009
It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position
of the registration mark.
E04010
It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position
of the registration mark.
E04011
It has exceeded detection area while
detecting the registration mark.
Check the media. Check the print position
of the registration mark.