GRAPHTEC FC9000 Series - Setting the Length of Overcut

7-4
Setting the length of overcut
Set the length of overcut with tangential mode.
Operation
1
Press the [COND/TEST] key.
CONDITION setting screen (1/3) is displayed.
2
Press the POSITION ( ) key.
CONDITION setting screen (2/3) is displayed.
Supplement
It is enabled when Tangential Mode is set.
When it is set to OFF, the screen below will be
displayed.
3
Press the [4] key (OVERCUT).
OVERCUT screen is display
4
Press the [1] key (Condition No.)
CONDITION No. screen is displayed.
5
Press the POSITION ( ) keys and select the CONDITION
No.
6
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(6&@NH\35(9,286
Condition No. will be selected and it will return to OVERCUT screen.