GRAPHTEC FC9000 Series - Change the Cutting Condition (Condition No.); Reset (Revert to the Initial State When the Power was Turned On.)

3-6
Change the cutting condition (Condition No.)
Go through the following steps to change the Cutting Condition (Condition No.):
Operation
1
Press the [ENTER] key in READY status.
CONDITION No. selection screen is displayed.
Supplement
It will return to state when the power is turned
on when the [ORIGIN] key (RESET) is pressed.
Please refer to for Reset (Revert to the initial
state when the power was turned on.).
2
Press the [1] key (No.1), the [2] key (No.2), the [3] key (No.3),
the [4] key (No.4), the [
] key (No.5), the [ ] key (No.6), the
[
] key (No.7), or the [ ] key (No.8), while simultaneously
pressing the [ENTER] key.
6HWWLQJZLOOEHFRQÀUPHGDQGLWZLOOUHWXUQWRGHIDXOWVFUHHQ
Reset (Revert to the initial state when the power was turned on.)
To revert to the initial state when the power was turned on, do following:
Operation
1
Press the [ENTER] key in READY status.
CONDITION No. selection screen is displayed.
2
Press the [ORIGIN] key (RESET), while simultaneously
pressing the [ENTER] key.
,QLWLDOL]DWLRQLVSHUIRUPHGDQG0(',$6(77,1*VFUHHQLVGLVSOD\HG