GRAPHTEC FC9000 Series - When Coordinate Axes Rotation Are Set; When Coordinate Axes Are Rotated after Origin Point Is Set

3-8
When coordinate axes rotation are set
If the origin point is moved while the coordinate axes are rotated, the origin point will move as shown below.
Supplement
See "Setting the Cutting Direction" about the rotation of the coordinate axes.
New origin
point
Original origin point
When coordinate axes are rotated after origin point is set
7KHRULJLQSRLQWZLOOEHLQLWLDOL]HGDVVKRZQEHORZLIWKHFRRUGLQDWHLVURWDWHGDIWHUPRYLQJWKHRULJLQSRLQW
'LVWDQFHDZLOOEHPDLQWDLQHGEXWGLVWDQFHEZLOOEHLQLWLDOL]HG
New origin point
Original origin
point
Original origin
point
Before setting After setting
aa
b
New origin
point
Supplement

7RXVHWKHRULJLQSRLQWPRYHPHQWDQGFRRUGLQDWHD[HVURWDWLRQWRJHWKHUDOZD\VURWDWHWKHFRRUGLQDWHD[HVÀUVWDQGWKHQPRYHWKH
origin point.

Coordinate value displayed after setting new origin point is a distance from the new origin point.