GRAPHTEC FC9000 Series - Check the Lines of Registration Mark

5-12
Check the lines of registration mark
$IWHUGHWHFWLQJUHJLVWUDWLRQPDUNVDFWXDOO\FRQÀUPPDUNVFDQQLQJRSHUDWLRQ
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [2] key (ARMS).
ARMS SETTING screen (1/3) is displayed.
Supplement
This function is not available when MARK TYPE
3 or MARK TYPE 4 is used.
3
Press the [3] key (MARK LINE CHECK).
MARK LINE CHECK screen is displayed.
4
Press the [1] key (TYPE1) or the [2] key (TYPE2).
The following message is displayed.
Supplement
When checking the lines of registration mark
using the mask registration mark, set the mask
width to 20 mm on the application software.
If it is 20 mm or less, the registration mark lines
cannot be checked properly.
a
a
a
a
a
a
a
a
a=20mm
5
Press the POSITION ( ) keys to move the tool to the
scanning start position (red circle).
MARK TYPE 1 MARK TYPE 2
Feed direction of media
Registration mark
Registration mark scanning start position