GRAPHTEC FC9000 Series - Cut Width; Manually Cross-Cut

7-30
Cut Width
The movement range of the blade in Cross Cut operation is from the outer edge of the leftmost grit roller to the
outer edge of the rightmost grit roller. The media should be set within this range.
Supplement
Replace the cross cut unit as per the following
guidelines.

3DSHUEDFNÀOPPPZLGHSDSHU
Approx. 3000 sheets (Model: PM-CC-002)

3ODVWLFEDFNÀOPPPZLGHSDSHUVKHHWV
Approx. 3000 sheets (Model: PM-CC-002)
Grit roller
Manually cross-cut
Cross-cut at the current tool carriage position.
If you manually cross-cut after moving the media with the POSITION (
) keys, you can separate the roll paper at
any position.
Operation
1
Press the [CROSS CUT] key in the default screen.
CROSS CUT screen is displayed.
Supplement
It will return to default screen without performing
the Cross Cut when you press the [ESC] key
(CANCEL).
2
Press the [1] key (CUT).
Cross-cut the media.