GRAPHTEC FC9000 Series - Aligning the Push Rollers

2-16
2.4
Aligning the Push Rollers
This section describes how to alignment of the push rollers.
Aligning the push roller
3RVLWLRQWKHOHIWDQGULJKWSXVKUROOHUVWRFRUUHVSRQGZLWKWKHZLGWKRIWKHPHGLD$GMXVWWKHSXVKUROOHUVVRWKDW
they are positioned above both the media and the grit rollers.
Positioning the push rollers within the grit roller position guides ensures that they are above the grit rollers.
Push roller
Grit roller
Grit roller position guide
(It isn't on the grit roller.) (It isn't on the grit roller.)
CAUTION
To move the push rollers, the media set lever must be in the lowered position.
Supplement
,ID>FRQÀUPLQJSXVKUROOHUSRLQW@PHVVDJHDSSHDUVDIWHUVHWWLQJWKHPHGLDDQGUDLVLQJWKHPHGLDVHWOHYHULWPHDQVWKHULJKWSXVK
roller is not on the right grit roller, or that the left or center push roller is not on the proper grit roller. Make sure everything is set
correctly.
When feeding long media (2 meters or more)
Position the push rollers at least 15 mm inside the edges of the media.
Push roller
Media
15 mm 15 mm