GRAPHTEC FC9000 Series - Overview of Axis Adjustment

13-4
13.2
Overview of Axis Adjustment
For D[LVDGMXVWPHQWWKHLQFOLQDWLRQRIWKHD[LVFDQEHDGMXVWHGEDVHGRQWKHFRRUGLQDWLRQRIDOLJQPHQWPDUNVJULW
,QDGGLWLRQWKHGLVWDQFHFDQEHDGMXVWHGE\HQWHULQJWKHGLVWDQFHRIHDFKSRLQW
Move the tip of each tool to the appropriate point.
8VHPHGLDWKDWKDVWKHSORWVJULWVRUDOLJQPHQWPDUNVUHTXLUHGWRÀQGWKH;DQG<D[LVDQGWKHRULJLQSRLQW
Alignment mark
The number of alignment marks is 2 points. The position of each alignment mark is as shown in the following
ÀJXUH
Alignment with 2 points
1st point or origin point
2nd point
Example of axis adjustment
%HIRUHDQGDIWHUDGMXVWPHQWD[LVDGMXVWPHQWVDUHPDGHDVVKRZQLQWKHIROORZLQJÀJXUH
Media that already cut and set again
$GMXVWPHQWSRLQW
(Origin point of the media already cut)
$GMXVWPHQW
point 2
Origin point
Reference of this plotter
Plotting
reference
$GMXVWLQJWKH
coordinate axes
New origin point
There is a misalignment between the X-Y axis and origin
point of the plotter and the media plotted.
The misalignment of the X-Y axis and origin point is
DGMXVWHGDQGWKHPLVDOLJQPHQWLVHOLPLQDWHG