GRAPHTEC FC9000 Series - RS-232 C Interface

9-3
RS-232C interface
:KHQXVLQJWKH56&LQWHUIDFHVHWWKHFRPPDQGVHWWLQJVVWHSVL]HVHWWLQJVZKHQXVLQJ*3*/
commands), origin point settings for HP-GL (when using HP-GL commands), and transfer conditions for the RS-
232C interface. The transfer conditions for the RS-232C interface can be set from the operations panel. The
transfer condition should be set to the same in the software used and in the FC9000. If there is a mistake in the
settings an error may displayed in the plotter and lack of data can cause a malfunction. In such a case, please
FRQÀUPWKHGDWDWUDQVIHUVHWWLQJVDJDLQ
* RS-232C interface depends on the sales area. For details, please contact the distributor where you purchased.
(See "Setting Origin Point When HPGL is Set")
6HH´6HWWLQJWKH67(36,=(µ
(See "Setting the Command (COMMAND)")
(See "Connecting with RS-232C")