GRAPHTEC FC9000 Series - Preparation for Plotting;Cutting (Take-up); Loading Roll Media (Paper); Mounting (Mounting the Stock Shaft)

18-6
18.3
Preparation for plotting/cutting (Take-up)
Loading roll media (paper)
This section explains in the FC9000-140.
CAUTION

3OHDVHEHFDUHIXOQRWWRJHW\RXUÀQJHUVSLQFKHGRQWKHPHGLDÁDQJHDQGUROOHUVHWFZKHQORDGLQJWKHPHGLD

Deviations and errors may result if the stock shaft is misaligned when plotting begins.
Mounting (Mounting the stock shaft)
1
Set up the stopper supplied in the cutting plotter in one stock
shaft.
(Keep the stopper screws slightly loose preliminarily.)
Stock shaft
Stoppers
2
Insert the stock shaft into the media stocker.
Make sure the stock shaft touches the roller.
* If using a TAKE-UP unit, insert the stock shaft into the
U-shaped groove on both ends of the media stocker.
Roller
Stock shaft
Media stocker