GRAPHTEC FC9000 Series - Setting Adjustment Between the Tools

7-22
7. 8
Setting Adjustment Between the Tools
If there is a misalignment between the tools, you can correct the misalignment by using this function.
In the case of Tool 1 - Tool 3
If there is a misalignment in the cutting/plotting between Tool 1 (tool attached to the backward of the tool holder)
DQG7RROWRRODWWDFKHGWRWKHIRUZDUGRIWKHWRROKROGHU\RXFDQFRUUHFWLWE\HQWHULQJWKHDGMXVWPHQWYDOXH
Supplement
Set "TOOL NO. SETTING" of tool condition 1 to 1 and set "TOOL" to Pen.
Set "TOOL NO. SETTING" of tool condition 2 to 3 and set "TOOL" to Cutter.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOL SETTING (1/4) screen is displayed.
Supplement
When the optional 2-pen type is used, the
following is displayed.
You can switch between "Tool 1-3" and "Tool
1-2" by pressing the [1] key.
3
Press the [2] key (TOOL OFFSET ADJ.).
TOOL OFFSET ADJ. screen is displayed.
4
Press the [2] key (TEST PATTERN).
The following message is displayed.