GRAPHTEC FC9000 Series - Cross cut the roll paper

7-29
7. 9
Cross cut the roll paper
The operation to separate media is called "Cross Cut".
You can manually cross-cut at any position or cross-cut automatically at the end of cutting.
7KHEODGHIRUFHWRFURVVFXWLVFDOOHG&URVV&XWIRUFHDQGFDQEHDGMXVWHG
CAUTION
'RQRWSODFH\RXUKDQGVZKHUHWKHEODGHVSDVV7KHUHLVDGDQJHURILQMXU\
Supplement

Cross Cut is available only when using roll media. Sheet media cannot be cross-cut.

Clean the cutting groove regularly with a cotton bud or the like. If the dust or the like accumulates, the cutter cannot operate properly.

,IFURVVFXWPHGLDLVSODFHGRQWKHPHGLDVHQVRUUHPRYHWKHFURVVFXWPHGLD,ILWLVQRWUHPRYHGLWLVMXGJHGDVDFXWIDLOXUHDQG
Cross Cut operation is performed again.

Set "Push roller sensor setting" and "Media sensor setting" to Enabled. If it is set to Disabled, Cross Cut operation is not available.