GRAPHTEC FC9000 Series - Setting Length of the Page

4-5
4
Press the [2] key (EXPAND).
SET EXPAND LIMIT screen is displayed.
Supplement

If the settings value is set to an area between
+1.0 mm and +10.00 mm, transfer direction
of the cutting area will also expand 5 mm
forward.

You can set the range between +10.0 and
-10.0 mm.
5
Press the POSITION ( ) keys and increase or decrease the
setting value.
Supplement
It will return to AREA PARAMETERS setting
screen (2/2) without changing the settings when
you press the [ESC] key (CANCEL).
6
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7
6HWWLQJZLOOEHFRQÀUPHGDQGLWZLOOUHWXUQWR$5($3$5$0(7(56
screen (2/2).
7
Press the [PAUSE/MENU] key.
It will return to default screen.
Setting length of the page
Length of 1 page when using the roll media is set.
2QO\WKHSDUWWKDWZLOOÀWLQWRWKHVHWSDJHOHQJWKZLOOEHFXWIRUWKHFXWWLQJGDWDWKDWLVORQJHUWKDQWKHVHWSDJH
length, and the exceeding part will not be cut.
Reference

Default page length is 2 m. When doing long cuts, check the setting of the page length.
* Please be sure to use the basket (option) when cutting media over 2 m long.

3DJHHMHFWLRQTXDOLW\DVVXUDQFHJRHVXSWRP,WGHSHQGVRQWKHPHGLDVSHFLÀHGE\*UDSKWHFDQGVHWWLQJFRQGLWLRQV
 8VHWKHEDVNHWRSWLRQ
 8VH06FRWFKFDO6HULHV
 6HWWKHVSHHGEHORZDQGWKHDFFHOHUDWLRQEHORZ,Q6LPSOHPRGHWKHUHLVQRQHHGWRVHWDQ\WKLQJVRLWLVQRWDYDLODEOH
 3HUIRUPSUHIHHGIRUWKHDPRXQWWREHXVHGEHIRUHFXWWLQJ
 /HDYHWKHPHGLDLQHQYLURQPHQWWRXVHIRUDGHTXDWHWLPHLIWKHGHYLDWLRQRIWHPSHUDWXUHDQGKXPLGLW\LVELJ
 6HWWKHERWKSXVKUROOHUVDWOHDVWPPLQVLGHWKHHGJHRIPHGLD

Set the sideway tension of the media uniform when setting the media when cutting long length. Media might come off the rollers
while cutting if it is not uniform.

Pull out the amount to use before cutting when you are using the roll media.

To reduce the shifting of the media, perform the pre feed to the full length to be cut (see "Pre Feed of Media (Paper or Marking
Film)". Also, pre feeding can be done automatically when the data is received (see "Perform Automatic Pre Feed When Cut Data is
Received", or done automatically when the media is loaded (see "Perform Automatic Pre Feed When Media is Set (Initial Feed)".
 3UHIHHGLQJZLOOVWDELOL]HWKHIHHGE\DFFOLPDWLQJWKHPHGLDWDNLQJRXWWKHVODFN

This setting will be saved even if the power is shut off.