GRAPHTEC FC9000 Series - Other Error Messages

16-12
Other Error Messages
Error
Displayed
LCD Display Cause Solution
E01001
to E01005
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01006
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01007
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01008
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01009
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01010
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01011
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01012
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01013
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01014 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01015
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01017
The plotter is defective.
Load on the motor was too large.
0RYHWKHREMHFWGLVWXUELQJWKHRSHUDWLRQ
and turn on the plotter after turning it off
once.
Do not use heavy media.