GRAPHTEC FC9000 Series - Page 335

16-13
Error
Displayed
LCD Display Cause Solution
E01019 The plotter is defective.
Load on the motor was too large.
0RYHWKHREMHFWGLVWXUELQJWKHRSHUDWLRQ
and turn on the plotter after turning it off
once.
Do not use heavy media.
E01021
The plotter is defective.
Load on the motor was too large.
0RYHWKHREMHFWGLVWXUELQJWKHRSHUDWLRQ
and turn on the plotter after turning it off
once.
Do not use heavy media.
E01022
The plotter is defective.
There was a heavy load on the up and
down function of the tool carriage.
Please clear any obstruction in the up and
down function of the tool carriage and turn
the power back on.
If the error display continues to show,
please contact the store where you bought
the product or our Customer Center.
E05001
'DWDODUJHUWKDQWKHEXIIHUVL]HFDQQRWEH
copied.
Perform normal cutting not using the copy
mode.
E05002
There is no data to copy. Perform normal cutting by sending the data,
then use the copy mode.
E05003
Media valid area to copy is too small. Use larger media.
&RQÀUPWKHFRS\VWDUWSRVLWLRQ
E05004 The push roller is not on the grit roller. Set the push roller on the grit roller.
E05006
Distance between the bottom left and top
right of the AREA setting is less than 10
mm.
Perform the AREA setting again.
E05007 Test pattern for the TOOL OFFSET ADJ.
cannot start plotting because the start
position is at the edge of the media.
Set the start position inside the media.
E05008
External memory (USB memory) cannot be
UHFRJQL]HG
Insert external memory (USB memory).
E05009
Barcode cannot be scanned. Check the print result of Barcode.
E05010 Barcode cutting is not available when
Rotation is set to ON.
Set Rotation is set to OFF to use Bacode
cutting.