GRAPHTEC FC9000 Series - Set the Take-up Function; Operation: Setting the Take-up to ON

18-15
Set the take-up function
When using the take-up function, set the take-up sensor to ON and AUTO PRE FEED (PrFEED) to ON, and set
WKHVDPHVHWWLQJDVWKHOHQJWKRIRQHMRE
CAUTION

When taking up, do not cut the perforations.

In consideration of overlapping with the support media, print a design with a margin of approx. 500 mm at the leading edge of the roll
media.

7KHOHQJWKRIRQHMREVKRXOGEHVHWZLWKLQP

When setting the number of data, take up to 20 m at one time.

If the TAKE-UP unit is not properly installed, the take-up menu will not be displayed.

When applying “continuous operation”, the media feed operation dedicated to continuous operation is performed even if Automatic
Pre Feed (PrFEED) is not set to ON.

Always open the basket during the take-up operation.

Due to the structure, the roll media is slacked by about 200 mm after the completion of the take-up operation.
Operation: Setting the take-up to ON
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETING screen (1/2) is displayed.
3
Press the POSITION ( ) key.
MEDIA SETING screen (2/2) is displayed.