18-14
8
Stick and secure the loaded roll media and the support
media using tape.
At the time of pasting, make sure that the end of the roll
media is facing up and stick straight.
The overlapping area should be approximately 1 cm.
* Please change the pasting place according to the media
length.
* In consideration of overlapping with the support media, print
a design with a margin of approx. 500 mm at the leading
edge of the roll media.
Support media
Tape
Roll media
Roll media
Approx. 1 cm
9
After securing with tape, feed the roll media to a position
where the overlapping portion between the roll media and
support media does not overlap the media guide, and set
that position as the origin.
See "Loading Media (Paper or Marking Film)" in Chapter 2.
Media guide
Overlapping
portion
To Next Page
Loading...
