2-21
2.6
Connecting to the Power
Turning on the power of the plotter.
Operation
1
Check that the power switch is turned off. (the " " side is
pressed down)
2
Connect one end of the provided power cord to the FC9000
AC line inlet and the other end to an electrical socket of the
rated supply voltage.
Supplement
When turning the power off, wait over 20
seconds before turning it on again, otherwise
problems may occur with the display.
3
Turn on the FC9000 by pressing the "|" side of the switch.
LCD on the control panel is lit.
Supplement
The Default Screen will appear after
purchasing the machine. See "2.5 About the
Default Screen" for more information.
This screen is described as "default screen"
in this document.
Settings such as initial media feed speed and
communication conditions can be performed.
4
,IPHGLDKDVQRWEHHQORDGHGWKHÀUPZDUHYHUVLRQQXPEHULV
displayed, followed by a prompt to load media.
Media set lever lowered
(The push roller is up)
Media set lever raised
(The push roller is down)
To Next Page
Loading...
