GRAPHTEC FC9000 Series - Setting the Speed

2-36
Setting the speed
Set the speed of the tool that is used in each of the condition numbers.
Setting range : 1 to10 (in 1 cm/s increment), 10 to 105 (in 5 cm/s increment)
Operation
1
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION setting screen (1/3)
without changing the settings when you press
the [ESC] key (CANCEL).
2
Press the [3] key (SPEED).
SPEED setting screen is displayed.
* Display may vary depending on the selected tool condition number.
3
Press the POSITION ( ) keys and select the tool condition
number (CONDITION No.).
Supplement
You can set the range between 1 and 10 (1 cm/
s-step) or 10 and 105 (5 cm/s-step).
4
Press the POSITION ( ) keys and increase or decrease the
setting value.
5
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7
6HWWLQJZLOOEHFRQÀUPHGDQGLWZLOOUHWXUQWR&21',7,21VHWWLQJVFUHHQ
(1/3).
Supplement
Depending on media width, speed and
acceleration settings, the acceleration of the
default screen is displayed as [*].
In this case, it operates with the value of the
calculated acceleration automatically.
6
Press the [COND/TEST] key.
It will return to default screen.