GRAPHTEC FC9000 Series - Attaching a Tool

2-5
2.2
Attaching a Tool
Attach a tool (cutter plunger, plotter pen) to the plotter.
Attaching a tool
When mounting the tool in the tool holder, please note the following.

Push the tool all the way into the holder until its flange contacts the upper part of the holder and then tighten
the screw firmly.

7RSUHYHQWLQMXU\DYRLGDEVROXWHO\WRXFKLQJWKHWRROLPPHGLDWHO\DIWHUWKHFXWWLQJSORWWHULVWXUQHGRQRU
whenever the tool is moving.
It is explained here using cutter plunger as an example.
CAUTION
:KHQSXVKLQJWKHWRROKROGHUZLWK\RXUÀQJHUVWKHEODGHWLSPD\EHSURWUXGLQJ7DNHFDUHQRWWRFXW\RXUÀQJHUV
Supplement

When using with half cutting and plotter pen, set the seal in Tool Holder (backward), and when using cutting out (perforated
cut), set the seal in Tool Holder (forward).

+DOIFXWWLQJPHDQVWKDWRQO\WKHPDUNLQJÀOPLVFXWRXWOHDYLQJWKHEDFNLQJVKHHWXQFXW

Cutting out means that the media is cut out completely.

6WUXFWXUHRI0DUNLQJÀOP
0DUNLQJÀOP
Backing
sheet
Mounting
1
Loosen the tool holder screw.
Tool holderBracket to hold tool
Bracket to hold tool
Tool holder
Top