GRAPHTEC FC9000 Series - About Using Strong Resilient Media; Notes on Plotting Data

18-3

About using strong resilient media.
The roll media taken up may swell and affect the take-up operation.
If the roll media swells, put tension on the roll media by inserting a paper core with the same width into the
slack part of the roll media. The swell may stop. Be sure to try it before using it.
When a heavy paper core is used, the media deviations may occur. Please use a light paper core that can
take up slack.
Paper core
7KHWUDMHFWRU\RIUROO
media
Notes on plotting data

When taking up, do not cut the perforations.

In consideration of the overlap of the support media, print a design with a margin of about 500 mm on the
leading edge of the roll media.

When creating a data, the length of one data should be within 1.2m.

Set the number of data that can fit on a roll of up to 20 m for the amount of one take-up.