GRAPHTEC FC9000 Series - Setting Origin Point When HP-GL Is Set

3-9
Setting origin point when HP-GL is set
When using the HP-GL command, the origin point is set to either the lower left of the cutting area or the center.
Supplement

When using the GP-GL command, this setting does not affect the operation.

See "Settings of Controls from Computer" for setting the COMMAND.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the POSITION ( ) key (I/F).
INTERFACE screen (1/3) is displayed.
3
Press the [3] key (HP-GL ORIGIN POINT).
HP-GL ORIGIN POINT setting screen is displayed.
4
Press the [1] key (LOWER LEFT) or the [2] key (CENTER).
Supplement
It will return to INTERFACE screen without
changing the settings when you press the [ESC]
key (CANCEL).
5
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7
6HWWLQJZLOOEHFRQÀUPHGDQGLWZLOOUHWXUQWR,17(5)$&(VFUHHQ
6
Press the [PAUSE/MENU] key.
It will return to the default screen.