GRAPHTEC FC9000 Series - Cross Cut Force

4-21
4.4
Cross Cut Force
$GMXVWWKHEODGHIRUFHZKHQFURVVFXWWLQJ
The setting range of Cross Cut force is 1 to 48. The force becomes strong when the set value is large.
If the medium is thin, set the setting value to a small value, if it is thick, set it large.
Reference
This setting will be saved even if the power is shut off.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETTING screen (1/2) is displayed.
3
Press the POSITION ( ) key.
MEDIA SETTING screen (2/2) is displayed.
4
Press the [2] key (CROSS CUT FORCE).
CROSS CUT FORCE screen is displayed.