GRAPHTEC FC9000 Series - Setting the Pouncing Tool

17-3
3
0DNHVXUHWKDWWKHWRROEUDFNHWLVHQJDJHGPRXQWHGÀUPO\
RYHUWKHÁDQJHDQGWKHQWLJKWHQWKHVFUHZ
Flange
Bracket to hold tool
Removing the Pouncing Tool
When removing the pouncing tool, turn it counterclockwise to remove the perforating tool.
Setting the Pouncing Tool
Set the distance of the holes when continuous holes are to be punched.
Operation
1
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
Press the [1] key to change the CONDITION No.
It will return to CONDITION setting screen
without changing the settings when you press
the [ESC] key (CANCEL).
2
Press the [2] key (TOOL).
TOOL setting screen is displayed.