GRAPHTEC FC9000 Series - Enabling;Disabling the Push Roller Sensors (PUSH ROLLER SENSOR)

10-5
5
Press the [1] key (ENABLED) or the [2] key (DISABLED).
Supplement
It will return to ADVANCE screen (4/4) without
changing the settings when you press the [ESC]
key (CANCEL).
6
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7
6HWWLQJZLOOEHFRQÀUPHGDQGLWZLOOUHWXUQWR$'9$1&(VFUHHQ
7
Press the [PAUSE/MENU] key.
It will return to default screen.
Enabling/Disabling the push roller sensors (PUSH ROLLER SENSOR)
This function enables or disables the push roller sensors that detect the width of the media.
CAUTION
Usually, please use it while set to “ENABLED”.
When set to “DISABLED”, the cutting mat may be damaged. Please always set the “AREA”.
Operation
1
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
2
Press the POSITION ( ) key (ADV.).
ADVANCE screen (1/4) is displayed.
3
Press the POSITION ( ) key.
ADVANCE screen (4/4) is displayed.