GRAPHTEC FC9000 Series - Page 336

16-14
Error
Displayed
LCD Display Cause Solution
E05011 Barcode cutting is not available when
Mirror is set to ON.
Set Mirror is set to OFF to use Barcode
cutting.
E05012
7KHGHVLUHGÀOHFDQQRWEHIRXQGLQH[WHUQDO
memory (USB memory).
6DYHWKHGHVLUHGÀOHLQH[WHUQDOPHPRU\
(USB memory).
E05013
Start mark cannot be scanned. Check the print result of start mark.
Move the tool carriage above the start mark.
E05014
The selected connection destination
cannot be found.
Connect to the selected connection
destination using USB or LAN cable.
E05015 There is no appropriate cutting data for the
data link server.
Check the data link server.
E05016
The communication to the data link server
is not established.
Check the data link server.
Increase the time until the timeout.
E05017
Media set lever is lowered. Set the media again.
E05018 A trouble occurs in the data link server. Restart the data link server.
E05019
A trouble occurs in communication to the
data link server.
Set the media again.
Turn the power off and then on again
E05020
The connection destination is not USB
memory
Set connection destination to USB memory.
E05021
The type of Barcode is different. Apply the appropriate Barcode.
E05022
Media skew is detected. Set the media again.
Increase the skew detection set value.
E05023 Data link server is not activated. Activate data link server.