GRAPHTEC FC9000 Series - Page 173

7-23
Supplement

It will return to TOOL OFFSET ADJ. screen
without changing the settings when you press
the [ESC] key (CANCEL).

Pressing the POSITION and [SLOW] keys at
the same time moves the tool carriage slowly.
5
Press the POSITION ( ) keys to move the tool carriage
to the position where the test pattern is plotted.
Move it inside of a cutting area greater than 50 mm on both
the X and Y axes.
6
&RQÀUPWKHWRROSRVLWLRQDQGSUHVVWKH>(17(5@NH\
Using the pen plunger (Tool 1), plot a "+" mark.
Next, using the pen plunger (Tool 3), plot a "+" mark.
When plotting is completed, TOOL OFFSET ADJ. screen is displayed.
7
Using "+" plotted with the pen plunger (Tool 1) as a reference,
measure how much the "+" cut by the cutter plunger (Tool 3)
GHYLDWHV)RUH[DPSOHLQWKHFDVHVKRZQLQWKHÀJXUHLWLV
deviated in the -X direction / + Y direction, so enter X = + *
mm, Y = - * mm.)
X mm
Y mm
"+" plotted with
the cutter plunger
(Tool 1)
"+" plotted with
the cutter plunger
(Tool 3)
8
Press the [3] key (X=+0.0mm).
7RRO,QWHUYDO$GMXVWPHQW;VFUHHQLVGLVSOD\HG