GRAPHTEC FC9000 Series - Page 129

5-15
Supplement
It will return to ARMS SETTING screen (2/3)
without changing the settings when you press
the [ESC] key (CANCEL).
6
Press the [4] key (TEST ARMS SENSOR).
TEST ARMS SENSOR screen is displayed.
Supplement
It will return to TEST ARMS SENSOR screen
without changing the settings when you press
the [ESC] key (CANCEL).
7
Press either the [1] key (TYPE 1) or the [2] key (TYPE 2)
depending on the type of the registration mark to be used.
Following message is displayed.
8
Move the tool to the position to start scanning of the
registration mark by pressing the POSITION (
) key.
Registration mark scan area
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Feed direction of media
Move the tool inside this
area
Move the tool inside this
area
Supplement
Following error is displayed when the
registration mark was not scanned properly.
Press the [1] key (RETRY) to scan again, or the
[ESC] key (CANCEL) to exit.
9
&RQÀUPWKHSRVLWLRQRIWKHWRRODQGSUHVVWKH>(17(5@NH\
The plotter will automatically detect the registration mark and cut the
peak of each registration mark.
10
 &RQÀUPWKHFXWWLQJUHVXOW
6HH$GMXVWLQJIRUWKH5HJLVWUDWLRQ0DUN6FDQ3RVLWLRQDQGDGMXVWLIWKH
cutting position is shifted.