GRAPHTEC FC9000 Series - Page 13

C-3
Change the cutting condition (Condition No.) ....................................3-6
Reset (Revert to the initial state when the power was turned on.) ....................3-6
3.3 Setting the Origin Point ................................................ 3-7
When coordinate axes rotation are set .........................................3-8
When coordinate axes are rotated after origin point is set ..........................3-8
Setting origin point when HP-GL is set .........................................3-9
3.4 Setting the Cutting Direction ...........................................3-10
3.5 Stop Cutting .......................................................3-12
Pause and resume cutting .................................................3-12
Stop cutting .............................................................3-13
Chapter 4: Convenient Functions
4.1 Settings for Cutting ...................................................4-2
Setting cutting area ........................................................4-2
Setting cutting width (EXPAND). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-4
Setting length of the page ...................................................4-5
Setting mirror ............................................................4-7
Set the enlarge/shrink scale (Scale) ...........................................4-8
4.2 Copy (Duplicate Cutting) ..............................................4-10
When media change mode is OFF .........................................4-10
When media change mode is ON ..........................................4-13
When Media Change Mode is OFF and Cross Cut is ON. .......................4-15
4.3 Panel Cutting .......................................................4-19
4.4 Cross Cut Force ....................................................4-21
 'XDO&RQÀJXUDWLRQ ...................................................4-23
User Switching ..........................................................4-23
Chapter 5: ARMS (Advanced Registration Mark Sensing System)
5.1 Outline of ARMS .....................................................5-2
Shape (Pattern) of the Registration Mark and Origin Point .........................5-3
Scan range necessary to detect the registration mark .............................5-4
Positioning of the media and the registration mark ...............................5-6
&XWWLQJDUHDZKHQDGMXVWLQJWKHUHJLVWUDWLRQPDUN ................................5-6
Automatic detection of registration mark position .................................5-7
Media that registration mark cannot be detected .................................5-7
 6HWWLQJDQG$GMXVWPHQWRI$506 ........................................5-8
Set the MARK SCAN Mode .................................................5-8
Checking the recommended setting of registration mark ..........................5-10
Check the lines of registration mark ..........................................5-12
Test the registration mark sensor ............................................5-14
$GMXVWLQJIRUWKHUHJLVWUDWLRQPDUNVFDQSRVLWLRQ ................................5-16
$GMXVWDIWHUSORWWLQJWKHDGMXVWPHQWUHJLVWUDWLRQPDUN ..........................5-16
'HWHFWWKHUHJLVWUDWLRQPDUNIRUDGMXVWPHQWRQWKHPHGLDDQGHQWHUWKHYDOXH .........5-20
Setting the registration mark automatic detection ...............................5-23
Setting speed of the registration mark scan ....................................5-25
Set cross cut between registration marks ......................................5-27