GRAPHTEC FC9000 Series - Outline of Manual Position Adjust

6-2
6.1
Outline of Manual Position Adjust
With PDQXDOSRVLWLRQDGMXVWWLOWRIWKHD[HVDUHDGMXVWHGXVLQJWKH32,17632,176RU32,176DGMXVWPHQW
PDUNVJULWVRUUHJLVWUDWLRQPDUNVDVDVWDQGDUG7KHGLVWDQFHEHWZHHQHDFKSRLQWFDQDOVREHHQWHUHGWRDGMXVW
the distance.
Move the tip of each tool to the appropriate point.
8VHPDJQLÀHURUOLJKWSRLQWHUDVDWRROWRPDWFKHDFKSRLQWV
8VHWKHPHGLDZLWKSULQWVDGMXVWPHQWPDUNVVXFKDVJULWVRUUHJLVWUDWLRQPDUNVQHFHVVDU\WRJHW;<D[HVDQG
origin point.
Setting mark scan mode and number of adjustment marks
To perform the AXIS ALIGNMENT, set the MARK SCAN MODE to "AXIS ALIGNMENT".
6HOHFWWKHQXPEHURIWKHUHJLVWUDWLRQPDUNVDGMXVWPHQWPDUNVIURP32,17632,176RU32,176ZKHQWKH
0$5.6&$102'(LVVHWWR$;,6$/,*10(173RVLWLRQRIHDFKDGMXVWPHQWPDUNVDUHDVIROORZLQJ
Adjust with 2POINTS
32,176DGMXVWPHQWZLOOVFDQUHJLVWUDWLRQPDUNVDOLJQHGLQWKHPHGLDWUDQVSRUWDWLRQGLUHFWLRQZKHUHWKH
DGMXVWPHQWLVGRQHPHDVXULQJWKHWLOWLQJRIWKHD[LVDQGWKHGLVWDQFHEHWZHHQWKHUHJLVWUDWLRQPDUNV7KLV
DGMXVWPHQWLVD[LVDGMXVWPHQWWLOWDGMXVWPHQW
If the loaded media is tilted as shown below, position of the scanned registration mark is shifted from the position
ZKHUHLWVKRXOGEH7LOWDQGGLVWDQFHFDQEHDGMXVWHGE\FRPSDULQJWKHVHFRRUGLQDWHYDOXHV
Feed direction of media
Second registration mark
Tilt
Original registration mark position
Difference in X
First registration mark
Difference in Y