GRAPHTEC FC9000 Series - Manual Position Adjust

6-4
6.2
Manual Position Adjust
Method of PDQXDOSRVLWLRQDGMXVWLVGHVFULEHGKHUH
Supplement

$GMXVWPHQWZLOOEHFOHDUHGLIIROORZLQJLVGRQHDIWHUVHWWLQJWKHDGMXVWPHQW
 6HWQHZRULJLQSRLQW
 6HWWKHPHGLDDJDLQ
 6HWURWDWLRQRUPLUURU6HWWKHURWDWLRQRUPLUURUSULRUWRWKHD[LVDGMXVWPHQW
 $[LVDGMXVWPHQWZLOOFRQYHUWLQDFFRUGDQFHZLWKURWDWLRQRUPLUURULQWKLVFDVH

:KHQWKHLQFOLQDWLRQRIWKHD[LVLVWRRODUJHZKHQVHWWLQJWKHÀUVWDQGVHFRQGSRLQWWKHÀUVWDQGWKLUGSRLQWWKHWKLUGDQGIRXUWKSRLQW
RUWKHVHFRQGDQGIRXUWKSRLQW$QJOHDGMXVWPHQWHUURUSOHDVHUHVHWZLOOEHGLVSOD\HG$IWHUVHWWLQJWKHPHGLDVRDVWRPDNHWKH
LQFOLQDWLRQVPDOOSOHDVHSHUIRUPDGMXVWPHQWRSHUDWLRQV

$[LVDGMXVWPHQWZLOOEHFOHDUHGZKHQSRLQWDQGSRLQWLVVHWWRVDPHSRLQW
Operation
Supplement
&RQÀUPWKDWWKHSXVKUROOHULVVWHDGLO\RQWKH
media within the range of media movement. This
DGMXVWPHQWLVEDVHGRQDVVXPSWLRQWKDWPHGLD
is slightly tilted. Media might fall off if the tilting
of the media is too large.
1
Load the media on which the registration mark patterns are
printed.
(See "Loading Media (Paper or Marking Film)".)
2
Set a cutter plunger or a pen in the tool holder.
3
Press the [PAUSE/MENU] key.
MENU screen is displayed.
4
Press the [2] key (ARMS).
ARMS SETTING screen (1/3) is displayed.