GRAPHTEC FC9000 Series - Page 148

6-6
Supplement
If the MARK SCAN MODE screen does not
appear, press the [2] key (ARMS) in the MENU
screen.
12
Press the [3] key (DURING DETECTION).
The following message is displayed.
Supplement
Pressing the POSITION and [SLOW] keys at the
same time will move the tool carriage slower.
13
Press the POSITION ( ) key to move it to the
DGMXVWPHQWPDUNSRVLWLRQ
Supplement

Repeat steps 13 to 14 when the message
prompting to move to the next registration
mark is displayed.

Number of times to repeat steps 13 to 14 differs
GHSHQGLQJRQWKHVSHFLÀHGQXPEHURIWKH
registration mark positions. Follow the message
that is displayed.

It will return to default screen without scanning
the settings when you press the [ESC] key
(CANCEL).
14
 &RQÀUPWKHSRVLWLRQRIWKHWRRODQGLILWLV2.SUHVVWKH
[ENTER] key (SET).
2QFHDOOWKHDGMXVWPHQWPDUNVDUHVSHFLÀHG',67$1&(VFUHHQLV
displayed.
Supplement

Measured distance is displayed in the top
line in the DISTANCE input screen. Input
value (initially same as measured value) is
displayed under that.

If the input value is not changed, it will
assume that there is no difference between
measured distance and the distance in the
data.

Press the [SLOW] key to select the setting
digits.
15
Press the POSITION ( ) keys to set the original distance on
the data.