GRAPHTEC FC9000 Series - Page 236

12-6
Supplement

If the USB memory is not inserted, the
following is displayed.

When the Rotation is set to ON, the following
display is displayed.

When the Mirror is set to ON, the following
display is displayed.

When the Panel Cutting is set to ON, the
following display is displayed.

In the case of a barcode of roll media, the
following will be displayed for the second and
subsequent sheets.
4
Press the [3] key (BARCODE CUT).
The following message is displayed.
5
Press the [1] key (STANDARD BARCODE ) or the [2] key
(ROLL PAPER BARCODE ).
The following display is displayed.
<Standard barcode> <Roll paper barcode>
6
Press the POSITION ( ) key to move the tool to the
start mark position.
Supplement

If the start mark is not scanned the following
display is displayed.
Check the print result of start mark and the
detect start position etc.
7
&RQÀUPWKHWRROSRVLWLRQDQGSUHVVWKH>(17(5@NH\
The barcode is scanned. On completing it, the following screen is
displayed.