GRAPHTEC FC9000 Series - Offline Output from USB Memory

13-17
13.8
 2IÁLQH2XWSXWIURP86%0HPRU\
Dedicated data that was created by the application software can be saved in the USB memory and output from
the cutting plotter.
6HOHFWWKHGDWDIURPWKHPHQXRIWKHSORWWHUDQGWKHQRXWSXWLWLQRIÁLQH
Supplement

Only 1-byte alphanumeric characters (ASCII) are supported.

:LQGRZVSURKLELWHGFKDUDFWHUV"!_HWFDUHQRWDYDLODEOH

Limit of the number of display characters is 25 characters. More characters than 25 can be displayed by scrolling.

Scroll is displayed after a few moments after selecting the item.

The extension is "xpf", "plt".

The folder is surrounded by '<' and '>'.

Name is sorted in ascending order.

Files and folders can be obtained up to 64.

Files in the second level folder is not available.
Operation
1
Insert the USB memory that saved the dedicated data to the
plotter.
2
Press the [PAUSE/MENU] key.
MENU screen is displayed.
3
Press the POSITION ( ) key (MEM.).
OFF-LINE OPERATION screen (1/1) is displayed.