GRAPHTEC FC9000 Series - Page 264

13-20
6
After completing it, press the [ENTER] key.
CONDITION setting screen is displayed.
7
Press the [COND/TEST] key.
It will return to default screen.
&RQÀUPWKHUHVXOWVRIWKHFXWWHVW
&RQÀUPWKHFXWWHVWUHVXOWVDQGDGMXVWWRRSWLPDOVHWWLQJ5HSHDWFXWWHVWDQGDGMXVWPHQWXQWLORSWLPDOFXWLV
achieved.
Adjustment of offset
6HH6HWWLQJWKH7RRODQGDGMXVWWKHRIIVHWYDOXHLIWKHFRUQHULVQRWFXWRULILWLVFXWWRRPXFK
Supplement
How to check offset
Check if the offset value is set correctly by following.
1RWHQRXJKDGMXVWPHQW
Increase the offset value.
Optimal offset value.
7RRPXFKDGMXVWPHQW
Decrease the offset value.
Check the UP length when cutting.
When the UP length is not enough, those that
are cut during cutting, may come off.
UP length