GRAPHTEC FC9000 Series - Page 281

14-7
Step 4: Cut the printed media.
Cut the media prepared in Step 3 with the cutting plotter.
Operation
Supplement

For loading media, see "Loading Media (Paper
or Marking Film)".

If a registration mark scanning error occurs,
check the registration marks etc. (See
"ARMS".)
4-
1 Load the printed media on the cutting plotter.
Feed direction of media Feed direction of media
MARK TYPE 1 MARK TYPE 2
4-
2 Send the cutting data to the cutting plotter.
When using Graphtec Pro Studio
1
Click on the "Cut Contour" icon.
Supplement
The ROTATE can be set only when using
4POINTS.
For other registration marks, load the media
according to the orientation of the preview.
2
The "Cut Contour" screen is displayed.
Set the ROTATE to
to match the setting direction of
the media.
Press the "Send".
Supplement
When the "Cut Contour" screen is displayed
IRUWKHÀUVWWLPHWKH$GG'HYLFHVFUHHQLV
displayed. Follow the instructions on the screen
to select the model name to use.

For USB connection, select the "Graphtec
USB".

For network connection, select the "TCP/IP"
and then enter the IP address of the cutting
plotter.